Engineering design training (autocad, pdms, p&id) tarining in lagos axis
Due to the ongoing trend of things in Nigeria industries where almost all aspect of Nigerian industries is been headed and managed by expatriates due to low technical knowhow of Nigerian graduates, a local content policy had been designed by the federal government to empower Nigerians in the management
of their affairs in the absence of expatriates. To achieve this, strategic plans had been mapped out to train and re-train Nigerians to this effect.
On this note, it had been of paramount interest to train graduate engineers in the use of sophisticated software like PDMS, P&ID, AUTOCAD, HYSYS, CEASER II, SOLID WORKS, for engineering designs.
COURSES ON TRAINING
AutoCAD: (A software for all class of engineers, technologists and scientist)
PDMS: (used by mechanical engineers, piping and layout engineers, structural and civil engineers etc).
P&ID: (Software that shows detail schematic arrangement of piping, equipment, inline components (Valves, Reducer), control instruments in a process plant), suitable for Process, Mechanical, Instrumentation engineers.
Aspen-Hysys: (used by process engineers, chemical engineers, petroleum engineers, industrial chemist etc)
Petrel: (used mostly by petroleum and gas engineers ,geologist, geo-physicist etc)
CEASER II: Use for pipe stress analysis
1.AUTOCAD
Introduction to the use of AutoCAD 2D commands
Application in designing of a simple house plan.
Application in electrical surface design and electronic circuit
Simple 2D piping design.
Piping and instrumentation (P&ID) design modeling and piping isometrics
General hatching and gradient modeling.
Introduction to 3D design modeling.
Development of 3D house plan model and roofing.
Introduction to 3D piping modeling
Modeling of mechanical parts and components.
Rendering and material modeling
2. PDMS (Plant Design Management system)
Introduction to different modules of PDMS
Application of design module
Structural design of beams/column ,walls/floor, panels/plates and access, stairs and ladder modeler.
Equipment application is ranging from pumps, distillation columns, storage vessels, exchangers etc
Pipe work routing.
HVAC design modeling, Cable tray, hangers and supports
Converting PDMS Draft and Isodraft to AUTOCAD
Introduction to PDMS project designed to various standards and layout interpretation.
3. OIL AND GAS PROCESSING DESIGN USING ASPEN HYSYS.
Introduction to process engineering and application
Flash calculation and utilities.
Propane Refrigeration loop
Refrigerated Gas Plant
NGL Fractionation Train
Oil Characterization
Gas Gathering
Two-Stage Compression
Acid Gas Sweetening with DEA
Natural Gas Dehydration with TEG
Reporting in Aspen HYSYS
4. Petrel (for sub-surface reservoir modeling and simulation studies).
Introduction and data importation
Seismic interpretation
Fault modeling
Vertical layering
Facies modeling
Petro-physical modeling
Reservoir mapping
Well correlation
Management: Ken Technologies
Tel: 08060360538, 08028553955
Venue : 8, Omotayo Bello Street, Thomas Estate, Ajah, Lagos
Along Abraham Adesanya Road, By Doren Hospital, Gate.
Email: [email protected]
How to apply/enquiry:
Please forward your name, course title and when you wish to start to [email protected]. For further Equiries call, 08060360538, 08028553955.
Lecture/ Training start, Saturday, 3rd May, 2014.
