Instrumentation and Control training in PH......

OIL AND GAS ENGINEERING DESIGN TRAINING FOR P&ID, PLC & SCADA 2013


ENGINEERING DESIGN TRAINING FOR P&ID, PLC & SCADA 2013

Piping and instrumentation diagram
A piping and instrumentation diagram/drawing (P&ID) is a diagram in the process industrywhich shows the piping of the process flow together with the installed equipment and instrumentation.

A piping and instrumentation diagram/drawing (P&ID) is defined by the Institute of Instrumentation and Control as follows:


A diagram which shows the interconnection of process equipment and the instrumentation used to control the process. In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on International Society of Automation (ISA) Standard S5. 1.
The primary schematic drawing used for laying out a process control installation.


P&IDs play a significant role in the maintenance and modification of the process that it describes. It is critical to demonstrate the physical sequence of equipment and systems, as well as how these systems connect. During the design stage, the diagram also provides the basis for the development of system control schemes, allowing for further safety and operational investigations, such as the hazard and operability study (HAZOP & HAZID).
For processing facilities, it is a pictorial representation of


Key piping and instrument details
Control and shutdown schemes
Safety and regulatory requirements
Basic start up and operational information



P&ID Course contents

Instrumentation and designation
Mechanical equipment with names and numbers
All valves and their identifications
Process piping, sizes and identification
Miscellanea - vents, drains, special fittings, sampling lines, reducers, increasers and swagers

Permanent start-up and flush lines
Flow directions
Interconnections references
Control inputs and outputs, interlocks
Interfaces for class changes
Computer control system input
Identification of components and subsystems delivered by others
Mechanization of P&ID
Gap Analysis etc….




At the end of the training real projects with live datas from SHELL Pet. Dev Co. will be used to illustrate
***Interpretation/mechanization of P&ID


Date: March, April 4th, 12th, 26th 2013 etc…
Venue: SIEC CONSULT LTD
315 Aba Road
2ND FLOOR, IZZI HOUSE BY IZZI BUS STOP
ABA ROAD, PORT HARCOURT
RIVERS STATE
Phone: +2348064919891, +2348035992896, +2348122965823, +2348154645666
Special considerations for corp members!

PROGRAMMABLE LOGIC CONTROLLERS (PLC) using Omro Syswin software


Introduction to PLC
What is control in PLC
Ladder Programming
Assembling of PLC
Addressing PLC
Rack Layout and Addressing
Omro Syswin software and features



SUPERVISORY CONTROL AND DATA ACQUISITION (SCADA)


What is SCADA
Process control and SCADA
Types & Designs of SCADA
Addressing in SCADA
SCADA software for configuring control systems

Venue: SIEC CONSULT LTD
315 Aba Road
2ND FLOOR, IZZI HOUSE BY IZZI BUS STOP
ABA ROAD, PORT HARCOURT
RIVERS STATE
Date: March, April 4th, 12th, 26th 2013 etc…
Phone: +2348064919891, +2348035992896, +2348122965823, +2348154645666
Special considerations for corp members