Pipe stress analysis using caesar ii
CAESAR II is a software used in the oil and gas industry for analysing the amount of stresses developed in a piping system due to weight ,thermal and occasional loads such as wind ,earthquake ,wave etc .Hence,providing support where needed on the system to prevent the failure of the system and to also keep the stress developed within the allowable limit as specified by the relevant codes eg ASME B31.3.
An opportunity is here to acquire a comprehensive training on not just the software but about Pipe Stress analysis and become a Pipe Stress engineer.The course contents are stated below
Inputs Required for Stress Analysis
Classification of Critical & Non Critical Lines
Pipe supports Selection & Span Calculation
Expansion Loop Design & Flexibility Calculations as per ASME B 31.3
Wind Load Calculation
Flange Leakage Calculation
Building of Input Model in CAESAR II
Introduction to LOAD CASES.& Building Up using CAESARII
Pump Suction Model & Analysis
Pump Discharge Model & Analysis
Static Analysis of Model
Qualifying Nozzle as per API 610 - Pump Nozzle Analysis
Interfacing between CAESARII AND PDMS
Call 08036614808 for further details.The instructor has trained both in Nigeria and India,hence,grab this opportunity and gain from his wealth of experience.
